ICON 2019–2021 Ford Ranger Stage 7 (Tubular) Suspension System
The ICON Stage 7 (Tubular) suspension for the 2019–2021 Ford Ranger is engineered to significantly improve on- and off-road ride quality by increasing wheel travel, damping capacity, and overall suspension control. The system pairs extended-travel 2.5 Series coilover shocks with remote reservoirs, ICON-engineered coil springs, tubular upper control arms with the patented Delta Joint, and tuned rear components to deliver predictable handling and improved compliance for a wide range of driving conditions.
- Extended-travel coilovers: Vehicle-specific tuned 2.5 Series coilovers with remote reservoirs for superior cooling and damping.
- Height adjustable: Front coilovers adjustable from 0–3.5 in. (0–2.5 in. on certain Tremor-equipped models) to accommodate larger tires and aggressive wheel fitment.
- ICON-engineered coil springs: Tuned springs for improved vehicle “feel” through the full range of travel.
- Tubular upper control arms: Correct front-end geometry, added caster, improved component clearance, and increased wheel travel when paired with extended-travel coilovers.
- Patented Delta Joint: Zinc-plated, greaseable high-angle joint that combines ball joint durability with uniball articulation for increased longevity and reduced noise.
- Aluminum-series rear shocks: 2.5 Aluminum Series piggyback reservoir shocks with vehicle-specific valving to balance front and rear performance.
- Multi Rate Leaf Packs: Lowered primary rear spring rate for improved compliance, with an additional removable leaf for increased capacity on more heavily outfitted vehicles.
- Foam bump stop kit: Increases rear-end compliance and progressive limiting of travel.
- Replaceable components: FK rod end bearings, fully rebuildable and revalvable shocks, and direct bolt-in design for straightforward installation.
- Durability and coverage: Lifetime guarantee against ICON fabricated component and coil spring breakage or manufacturer defect; Delta Joint carries ICON's 5 year limited warranty.
Notes
- Factory wheels and tires will fit.
- Recommended aftermarket wheel sizes include 17x8.5" with 5.75" backspace / 25mm offset and 18x9" with 6.00" backspace / 25mm offset.
- Recommended tire size up to 33x11.25"; larger tires may fit but fender trimming and modifications will be required.
- Shocks are fully serviceable. Coilover heights indicated are for a stock-equipped vehicle.
- Minor trimming required for the recommended tire size.
- Compatible with 2019–2021 Rangers equipped with aluminum steering knuckles only.
- Ranger XLT or Lariat models equipped with the Tremor package have a front lift height range of 0–2.5 in. over stock.
- Not compatible with Ranger Raptor.
- Typical ride-height ranges: Front raise 0–3.5 in. (0–2.5 in. with Tremor), rear raise approximately 0.375–2 in.
Icon Vehicle Dynamics K93207TA Stage 7 Suspension Lift Kit Lift 0-3.5" Ford Ranger 19-21 - Features
|
Note
|
Without Tremor Package
|
|
Note
|
With Aluminum Steering Knuckles
|
|
Note
|
With Aluminum Knuckles
|
|
Submodel
|
Lariat, XL, XLT
|
|
Series
|
Stage 7
|
|
Installation side
|
Front, Rear
|
|
Lift Height, inch
|
0-3.5"
|
|
Brand
|
Icon Vehicle Dynamics
|
|
Note
|
With Tremor Package
|
|
Box Weight
|
263 lbs
|
|
Box Length
|
48 in
|
|
Box Width
|
48 in
|
|
Box Height
|
17 in
|
|
UPCCode
|
840103422602
|
|
Fitment
|
2019||Ford||Ranger, 2020||Ford||Ranger, 2021||Ford||Ranger
|