Icon Vehicle Dynamics K53237T Stage 7 Suspension Lift Kit Lift 3-4.5" Toyota Sequoia 23-26

ICON Vehicle Dynamics Stage 7

The Stage 7 suspension system for the 2023–2025 Toyota Sequoia upgrades the rear shocks to 2.5 Aluminum Series remote reservoir units and adds dual-rate rear coils, a 2.5 Series remote-reservoir front coilover, tubular front upper control arms, and a front sway bar drop kit. The package is tuned to improve on- and off-road performance, increase shock cooling capacity, and provide a wider front lift range for proper stance and fitment of larger tires.

Front coilovers feature adjustable ride height and vehicle-specific valving with a larger 2.5" shock body for increased piston area and up to 40% more travel over stock. Remote reservoirs increase oil volume and heat dissipation to resist overheating and damper fade under heavy use.

Tubular upper control arms correct front-end geometry, add caster, improve component clearance, and include a serviceable Delta Joint PRO to allow full bump and droop travel while eliminating bind.

Rear dual-rate coils combine a softer ride-rate with a firmer overload-rate to deliver on-road comfort, improved bottoming resistance, and enhanced off-road capability. Spring rates provide roughly 2" of rear lift on non-TRD Sequoia models or maintain stock rear height on Sequoia models equipped with the TRD Off-Road package.

2.5 Aluminum Series rear remote reservoir shocks provide larger-diameter performance, improved damping consistency, and an internal Bump Zone that increases damping force during hard bottom-outs. Paired with the front coilovers, these shocks deliver balanced front-to-rear control and a refined driving experience.

• Vehicle-specific design for 2023–2025 Toyota Sequoia
• 2.5 Series front coilovers with remote reservoirs for improved damping and shock cooling
• Adjustable front ride height: up to 3–4.5" over stock (varies by submodel and equipment)
• Tubular upper control arms for added strength, durability, and alignment correction
• Delta Joint PRO with 90° total articulation for full suspension travel without bind
• Sway bar drop brackets to reduce link bind and allow full wheel travel
• Dual-rate rear coil springs for improved ride quality and bottoming resistance (provides either ~0" or ~2" rear lift depending on stock suspension)
• 2.5 Aluminum Series rear remote reservoir shocks for increased performance and balanced tune with the coilovers
• Shocks are fully serviceable, rebuildable, and re-tunable

Notes

• Most submodels will achieve approximately 3–4.5" of front lift and about 2" of rear lift over stock. Submodels equipped with the TRD Off-Road package or TRD Pro will typically have a front lift range of about 1–2.5" and remain at stock height in the rear.
• Advertised lift height ranges apply to stock-equipped vehicles; increasing vehicle weight with accessories may alter the lift range.
• Shocks are serviceable and rebuildable.
• Not compatible with vehicles equipped with Load-Leveling Rear Height Control air suspension.
• Not compatible with Adaptive Variable Suspension (AVS) equipped vehicles.
• Requires recalibration of Advanced Driver Assistance Systems (ADAS) after installation.
• For 4WD models without the TRD Off-Road package, additional front axle modifications may be required to prevent potential axle damage.
• If equipped with certain TRD skid plates or vehicle-specific accessories, additional hardware or modifications may be required for proper fitment.
• Wheel and tire fitment: supports up to 35" x 12.50" tires with minor fender trimming; recommended wheel offset around 25 mm (fitment varies by wheel design and vehicle submodel).

Icon Vehicle Dynamics K53237T Stage 7 Suspension Lift Kit Lift 3-4.5" Toyota Sequoia 23-26 - Features